Electrical power UNITS FOR LIFT TABLE one
General Description
This power unit is created solely for that compact lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be broadly used during the marketplace of logistic gadgets for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed by the solenoid valve with the speed managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is created solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve as well as pace controlled through the adjustable needle valve. Once the lift rises to a higher positoin, however the energy supply is lower, the lowering movement is managed by the guide override function.
Energy UNITS FOR LIFT TABLE three
Common Description
This energy unit is created solely for that big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve and the pace managed by a pressure compensated movement control valve.
Energy UNITS FOR LIFT TABLE 4
Standard Description
This power unit is made exclusively for the big lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as velocity controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the energy supply is minimize, the decreasing motion is managed by the guide override function.
Special Notes
one. This electrical power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean the many hydraulic elements concerned in advance of installation of the energy unit.
three. Viscosity of the oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. Oil altering is needed following the first a hundred operation hrs,afterwards once just about every 3000 hours.
five. The power unit shown is designed to be mounted vertically.