Observing a few guidelines for right set up is crucial on the trustworthy and suitable operation with the gearbox or gear motor.
The guidelines set out listed below are intended as being a preliminary manual to deciding on gearbox or gear motor. For helpful and correct installation, comply with the guidelines offered while in the set up, use the maintenances guide for your gearbox obtainable from our revenue department.
Following is actually a brief outline of installation guidelines:
a) Fastening:
Area gearbox on a surface supplying satisfactory rigidity. Mating surfaces needs to be machined and flat.
Mating surfaces has to be within definite geometric tolerances (see guide). This really is primarily genuine of flange-mounted gearboxes with splined hollow shafts.
In applications that involve large radial loads in the output finish, flange mounting is advisable for some gearbox sizes as this mounting tends to make utilization of the double pilot diameters presented in these gearboxes.
Ensure the gearbox is appropriate for the needed mounting place.
Use screws of resistance class eight.8 and above to secure the gearbox. Torque up screws on the figures
indicated in the related tables.
With transmitted output torque better than or equal 70% in the indicated M2max torque, and with
frequent movement reversals, use screws with minimal resistance ten.9.
Some gearbox sizes can be fastened working with both screws or pins. Of pin seated in the frame the gearboxes be not less than 1.five occasions pin diameter.
b) Connections
Safe the connection elements to gearbox input and output. Do not tap them with hammers or related tools.
To insert these elements, use the support screws and threaded holes presented around the shafts. Make sure you clean off any grease or protects from the shafts ahead of fitting any connection elements.
Fitting hydraulic motors.
Be cautious the O ring involving motor flange and gearbox input flange when assembling. Set up the
hydraulic motor just before filling lube oil in to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit needs to be such to make certain that brake is released instants ahead of gearbox commences and utilized soon after gearbox has stopped. Check that stress within the hydraulic line for brake release is at zero when gearbox is stopped.
Course of rotation
Motors are linked to the ideal electrical or hydraulic circuit as outlined by their direction of rotation.
When doing these connections, keep in mind that all gearboxes, no matter whether within the in-line or suitable angle style, have the very same path of rotation the two at input and output. For a lot more specifics of the connection of electrical and hydraulic motors, see pertinent sections within this catalogue.