The EP Greenhouse reducer is a compact and lightweight reduction gearbox with a limit switch system that is ideal for assembly of a locally available electric electric motor. The geared motor can be used in manually-managed or climate-controlled ventilation and screen systems in greenhouses. The quick and easy-to-install EP gear reducer is certainly rainproof and windproof. The gear reducer has a high protection course (IP65) and can be used in an ambient temperature of 0-60 °C.

The low-noise gear driver for Greenhouse includes a gearwheel transmission and a worm wheel transmission, which are integrated within an aluminum precision housing. The self-braking worm wheel tranny means that the drive shaft is locked when the decrease gear driver isn’t running. The fully sealed reduction geared motor has an growth chamber with a diaphragm to keep the gear oil at a low pressure under all conditions, even at high temperature ranges. Thanks to the use of an expansion chamber, the geared motor can be installed in any placement. There are no limitations, because there is no need for a bleed connect. The sealed reduction gear motor keeps the gear essential oil of the gearbox in optimum condition for its entire operating lifetime. The geared motor is suitable for discontinuous use, working course s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction gear reducer comes with an FT85 motor assembly flange, to which a suitable IEC standard motor can easily be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed within an included chamber and is usually enclosed by an impact-resistant plastic cover. The limit switch system is accessible and easy to adjust. The limit switch system’s maximum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gear motor comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The reducer for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of program of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temps of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, maximum activation time 25 a few minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching range of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).